|
Guard rail 1.10m
|
 |
|
|
| The guardrail 1.10m is the quick, easy way to erect a very dependable rail to cordon off drops. The guard rail 1.10m can be used at the edges of slabs, around openings, to provide protection at other spots where a fall is possible, or as a back rail for wall formwork. The guard rail 1.10m is all-steel and hot-dip galvanised for enhanced durability. |
|
|
|
-
along the edge of the slab, around openings or lift shafts
-
as a back rail for framed formwork
|
-
in soft concrete with the push-in or screw-in sleeve
-
by drilling into the post-set concrete
-
secured by a hex nut in the transverse hole of the framed panel
|
|
Handrail clamp S
|
|
|
|
| The handrail clamp S attaches easily anywhere along the timber formwork beam to provide safety for the people working on the structure. The clamp's range of adjustment is wide, so the handrail clamp secures in a large variety of situations on most building sites. |
|
|
|
-
platforms
-
floor and wall formwork
-
concrete slabs
|
-
with the 45° holders, allowing the rails to be pushed in from both directions
-
with a clamp range of adjustment from 2 to 45 cm
|
-
anywhere along the timber formwork beam
-
at the edge of finished concrete slabs
|
|
Handrail clamp T
|
|
|
|
| The handrail clamp T offers safety from start to finish: From pouring of the slab or the supporting structure to installation of the permanent guard rail. This clamp installs anywhere: On rebar hoops or bridge end beam anchors- no adapters or other add-ons needed! |
|
|
|
-
in bridge-building at the edge of the supporting structure
-
as protection against falls for precast stairway flights
-
as a back rail for wall formwork
|
-
to the rebar hoop of the supporting structure
-
with a bridge end beam anchor
-
directly to the sill, for example making use of the anchors set for guide rails
|
|
document download
|
|
pdf
KB |
download list of items
|
|
 |
|
|
|
|
 |
References |
|
)
)
)
){kind=small}
){kind=small}
){kind=small}
