Wall formwork FF100 tec

Wall formwork FF100 tec

The site-ready tim­ber-beam form­work for high-spe­c­i­fi­ca­tion con­crete fin­ish­es

The high-load tim­ber-beam form­work with a sys­tem grid

The pre-as­sem­bled stan­dard el­e­ments of Do­ka tim­ber-beam form­work FF100 tec com­bine the ad­van­tages of tim­ber-beam form­work with the grid-re­lat­ed ad­van­tages of a framed form­work sys­tem. They owe their ex­treme­ly high load-bear­ing ca­pac­i­ty to the new, heavy-du­ty Beam I tec 20 and the FF100 tec wal­ing WU14.

No lim­its on the pour­ing rate

up to a pour-height of 3.60 m, with on­ly two 20.0 form-tie points

Al­so with­s­tands the hy­dro­stat­ic pres­sure of new types of con­crete, thanks to

  • the min­imised de­flec­tion achieved by the sta­ble I tec 20 beam

  • high rigid­i­ty as the form­work beams are fas­tened to the wal­ings by weld­ed-on plates

Op­ti­mis­es equip­ment util­i­sa­tion and site lo­gis­tics

by its un­der­ly­ing 25 cm grid, with on­ly a small num­ber of dif­fer­ent el­e­ment widths

Cuts the com­mis­sion­ing quan­ti­ties and ren­tal du­ra­tion, thanks to

  • sim­pli­fied plan­n­ing based on a log­i­cal el­e­ment size-grid

  • rapid avai­l­a­bil­i­ty with no lead-times for pre-as­sem­b­ly

  • max­imised util­i­sa­tion of the com­mis­sion­ing quan­ti­ty

The fair-faced con­crete form­work

made of ready-as­sem­bled stan­dard el­e­ments

Pro­vides su­perb con­crete ap­pear­ance

  • as the form-ties are lo­cat­ed well in­side the el­e­ment, in a sym­met­ri­cal pat­tern

  • no screw im­prints in the con­crete, as the form-fac­ing is screwed on from the rear

  • as the pre-as­sem­bled beam grilles can be faced with any type of form-fac­ing

  • is suit­able for fair-faced con­crete of Class­es SB 1 to SB 4 (as defined in Ger­man Code of Prac­tice for Fair-Faced Con­crete)

Rapid form­ing with the ut­most work­place safe­ty

thanks to the sys­tem's ease of han­dling and op­ti­mised ac­ces­sories

Short­ens the form­ing-times, with its

  • im­proved form­work el­e­ment con­nec­tors with op­ti­mised pull-tight and push-apart func­tion for tighter joins and trou­ble­free fitt­ing of seal­ing tapes

  • up to 25 cm wide clo­sures in a 5 cm grid with no need for an ad­justable wal­ing ex­ten­sion

  • up to 20 cm wide in­fill zones with no need for ex­tra form-ties

  • ready-to-use plat­form sys­tems with in­te­grable lad­der­ways

  • op­ti­mised el­e­ment struts