NOTICE

General information:

â–ª Operators working off platform stairways and scissor-lift working platform can handle Dokadek panels up to a room height of 5.50 m.

â–ª At an extension length of 5.50 m, the floor props have to be positioned with the outer tube at the top, as otherwise the folding tripods cannot be installed.

â–ª Dokadek panels beside the wall can be pre-lifted in preparation for propping. The Dokadek assem­bling tool B is the only permissible tool for use when propping Dokadek panels.

â–ª Installation of the floor props with Dokadek heads (support head) can be assisted with the suspension tool.

Information relating to scissor-lift working platform:

â–ª Always comply with the instructions of the scissor-lift working platform (wind loads, floor gradient, etc.)!

â–ª Lifting force: min. 250 kg

â–ª Length of the platform’s working surface: approx. 2.50 m (for 2 persons plus width of the Dokadek panel); scissor-lift working platforms with telescopic working surface recommended.

â–ª Recommended width of the platform’s working surface:
1.00 - 1.25 m

â–ª Scissor-lift working platform must be suitable for outdoor use (wind loads).

CAUTION

➤ Do not change the height of the scissor-lift working platform while formwork set-up or stripping is in progress!

WARNING

Risk of tipping over!

➤ When assembly of the Dokadek system is in progress with the scissor-lift working platform, it is not permissible for additional horizontal loads to occur (F_H > 400 N).