The ground-support-free cantilever arm formwork for steel-composite and pre-cast concrete bridges
Doka bridge formwork ParaTop turns Large-area formwork Top 50 into a cantilever arm formwork that can be operated completely from above. The system's innovative insert-shoe makes it easy to erect, and compensates for any installation inaccuracy.
thanks to modular system concept
can be fixed to either concrete or steel superstructures (2 separate types of insert-shoe)
can easily be adapted to different cross-sections of cantilever slab with components from the modular Top 50 'kit'
does not collide with stiffening plates and is independent of shear-connector centres, as any bracket spacing can be selected within the permitted influence width
Less equipment and erection-work needed
as all work is carried out from the superstructure
there are no platforms or scaffolds beneath the superstructure, and formwork set-up & alignment, reinforcing, pouring and striking are all done only from above
the large influence widths of the brackets mean there are fewer bracket planes
formwork removal is made easy by the hard chrome-plated insert-cones, with no need for mounting-sleeves
Fast construction progress
assured by optimised system design
the assembly sequence is easy to understand, with only three ParaTop system components (insert-shoe, insert-channel, insert-cone)
erection and dismantling times are shortened by using bolted instead of threaded joints
'mount-ahead' facility for insert-shoes
hanging the cantilever arm formwork into place does not take much crane-time – there is no need to laboriously thread in tie-rods, as the insert-shoes are open at the front
This versatile cantilever arm formwork is attached to the bridge superstructure by means of re-useable diagonal anchors.
Thank you for your interest - Bridge formwork ParaTop.
Please, fill in the form below to receive more information on this topic and access it conveniently from your email later.
All listed fields are required.
Consent to cookies & data transfer to the United States of America
We request your consent
2) to the transfer to the United States of America of data obtained through the cookies
to continuously improve the functionality of our website,
to facilitate the experience of using the Doka Online Shop, or
to place advertising suitable for you as user on certain platforms.
See our Data Privacy Statement for more information about our cookies.
We also offer you the possibility of selecting your cookies (advanced cookie settings).
2) Data transfer to the United States of America
Some of our partners are entities established in the United States of America. We transfer your personal data manually or via an interface to these partners in the United States of America.
We would like to inform you that the ruling of 16 July 2020 (Court of Justice of the European Union judgement in case C-311/18, “Schrems II”) invalidates the EU - U.S. Privacy Shield decision that permitted a transfer of personal data to the United States of America. In consequence, as a third country the United States of America does not offer an adequate level of data protection.
For you as user, the risk that the transfer of personal data to an entity established in the United States of America is in particular that your data are subject to access by the United States authorities for monitoring and surveillance purposes and that to a large extent you are without effective administrative and judicial right of redress against such action by the United States authorities.
Personal data that we transfer to the United States of America are in particular IP addresses (Internet Protocol addresses).
We co-operate via various applications with the following recipients:
Monotype Imaging Holdings Inc.
Rocket Science Group LLC
The Trade Desk, Inc.
We require your explicit consent to continue sending your personal data to these providers.
You can revoke your consent with effect for the future at any time, by accessing the cookie settings on the website.